Jewelry Tutorial – How to Make An Angel Pendant Using Calla Lily Cone and Angel Wing Spacer Bead By Amoracast

Jewelry Tutorial – How to Make An Angel Pendant Using Calla Lily Cone and Angel Wing Spacer Bead By Amoracast

We are using 3mm bicones and 2 inch chain for the legs and feet, the Calla Lily cone for the skirt and Angel Wings.  First make the legs. 

Take a small head pin and thread the 3mm bicone.  Make a loop and slip the chain inside the loop before closing it by wire wrapping.  Use a pair of flat chain nose pliers, holding onto the loop as you wrap around it closed.  Then all you have to do is clip and do the same thing on the other side.

Using a head pin, thread through the middle so it has legs now and then put on the skirt with pearl for the body and angel wings.  All of the beads can be substituted, but the essential are the skirt and the angel wings.

Then make sure that it is hanging the way you want before using a pair of round nose pliers to make the loop.   Sometimes longer head pins are easier for grip and then switch to a pair of chain nose pliers, and do the same thing on the top as you have done with the feet. 

Close it up and make sure that it’s tight – the way you want.  Then clip and now you’re ready to put earring hooks on or put on the chain with a jump ring.

Find them here:

FDEUS – Sterling Silver Angel Wing Bead

FDEUV- Gold Vermeille Angel Wing Bead

FX06S – Brushed Calla Lilly Cone