Category Archives: Stringing and Leather

Jewelry Tutorial – Finishing A Wire Bracelet With Clasp

After you have strung all of the beads on wire, first thread the crimp bead (you can use a crimp tube if you prefer), then use a wire guardian (this will protect the wire from fraying in the future as you wear it often).  Before threading back into the crimp bead, add a solder ring […]

Jewelry Tutorial – Adding Ribbon Tie to Beaded Necklace

How to create a ribbon tie for a necklace when the beads are too small to thread the ribbon through? It is rather simple – start by ending the necklace with soldered jump rings.  Make sure they are big enough for the ribbon to go through when doubled.  In this video, I have 6mm jump rings […]

Easy Stretchy Bracelet

Perfect for both beginners and seasoned designers .  To make this bracelet you are going to need the following: 1.  Elastic Silk 2.  Smooth Round Rose Quartz   This video shows you how to string elastic bracelets with a stringing hack.  I often get asked what is the best elastic to use for stone bracelets.  I […]

How to Use Wire Guardians and Thread

In today’s video, we’re going to show you how to finish off a strand of small beads that have been strung with Cotton. I’ve added a bit of glue at one of the ends to help it thread through easier, I’ve also threaded on a crimp bead followed by a wire guard so it’s up […]

How To Use Clam Shell Bead Tips

Clamshell beads are a great way to finish off a strung necklace, we’ll walk you through it and there’s a video below for you to check out! To make things a little easier I’ve put a bit of glue on the tip of the string to create a needle-like tapered end which I’ll string through the […]

Join Waitlist We will inform you when the product arrives in stock. Please leave your valid email address below.